How to install the Water Float level detector in the water treatment system.

This video will provide a brief introduction to Water Float Level Detector installation in Water Treatment Equipment, this Level Detector will protect the pump from running automatically.

How to install the Water Float level detector in the water treatment system
Firstly, use Multimeter test which is the High Level Port, which low level Port,  wich one is common terminal.
Normally, Black color wire cable is the common terminal,  Yellow Color wire cable is High level port (water reach High Level then pump will stop run automactically), Blue color wire cable is low level port ( The water tank level in low state, the pump will run automatically)

Secondly, Connect the Float Level Detector to the Control Panel.

Thirdly, Install the Float Level Detector in raw water tank, if the level detector floated , then booster pump or Submersible pump will start automatically.
Once then level detector in verticality state, the pump will stop.

Hinada is the leading Water Treatment Equipment manufacturer, provide all types of water or wastewater treatment solution and equipment.